Скачати "DCS: F/A-18C Hornet | RAID Modes"

In earlier videos, we looked at the range while search and track while scan radar modes of the Hornet, but today I want to discuss the three RAID submode. These are handy to break out contacts within a radar resolution cell and alert of you contacts around your L&S or STT target. We will talk about Scan RAID, RAID SAM, and 1 Look RAID modes. SCAN RAID Scan RAID mode is your RAID mode used when in the Track While Scan, or TWS, radar acquisition mode. This mode focuses the TWS scan volume into a smaller three-bar, 10 nm by 22-degree area that provides a faster update rate. In addition to providing faster contact updates, may also breakout targets within a resolution cell. Once a contact has been designated as the L&S, pressing the RAID/HARM Sequence/FLIR FoV switch on the left throttle activates Scan RAID mode. The B-Sweep line is locked to the L&S azimuth and SCAN RAID appears at the bottom of the attack radar display. The scan centers on the L&S and it cannot be adjusted. Trackfiles and raw hits continue to be displayed but cannot be designated. To exit Scan Raid mode, press the RAID switch again, press reset, the L&S is less than 5 nm, the L&S is undesignated, or the L&S moves to the dugout. RAID SAM If instead of TWS you have a Single Target Track, or STT, lock and you press the RAID switch, the attack radar will enter RAID situational awareness mode, or RAID SAM. When commanded, a RAID cue is displayed at the bottom of the attack radar display. When in RAID SAM, the radar interleaves between scanning and the STT tracking functions. This is displayed as a 2-bar, 20-degree scan and it is centered on the STT target. Unlike Scan RAID, it is only a 5 x 5 nm search area around the target and only raw hits are displayed with their altitude in thousand of feet to the right. The update rate of these hits is lower than the STT and it repeats every 3.5 seconds. To exit, press the RAID switch again or undesignated. One-Look RAID When 1LookRAID is selected, boxed from the air-to-air radar data sublevel, the radar will automatically perform scans around the STT target. Targets immediately around the STT are displayed as raw hits (bricks). Unlike other RAID modes, the scale of the attack radar does not change; it simply displays raw hits around the STT. These hits cannot be designated.