Baixar "Stone road: types of stripping"

The video has subtitles in English and Greek Any stone road, regardless of its jointing, is an expensive construction. There are 3 ways of cutting (or stripping) a stone road: In-depth: when the solution is cleaned below the level of stones (for more details, see here https://www.youtube.com/watch?v=4QcHbiqbA6U&t=25s). It emphasizes the contour of each stone in the most favorable light. If you look at the tangential road with a deep jointing, then the solution is not visible - only stones aligned with smooth faces are visible. Therefore, in-depth punching, in our opinion, looks most beautiful. Flush with stone: when the solution forms a single plane with the faces of the stones. The smooth surface of such a road is convenient in operation: it is easy to clean, clean, and you can walk on it without clinging to the projections of stones or seams. Overlap: used when the stones are uneven, poorly treated or completely wild. The solution is poured on top of the seams and on the stones so as to smooth out as much as possible all the cavities and curves of each stone. The level of the solution may seem slightly higher than the level of the stones (since it is oriented towards the protruding tummies). The surface of the road turns out to be a relief, but relatively smooth, because the pounded smooth solution, and not a stone, takes up a larger visible area. Sometimes laying the road and without grout - between the stones visible concrete, which put the stones, with all its irregularities. This road does not look very neat, as if with torn seams. It will acquire its gloss with time, due to the weathering of stone and concrete. How to make a sweep? When the solution has dried, depending on the type of jointing, we clean the laid road in different ways: For even jointing and overlapping. First, we slightly clean the solution poured between the stones with a triangular scraper, then (or) with a metal brush. Then we take a foam sponge, dunk it in water, squeeze and rub the solution thoroughly, so that there are no cracks, roughness, rub it to smoothness and wash out each stone from the mortar. I recommend to carry out this zamyvka in three stages (we change water three times). We carry out the first zamyvka with a large amount of water in order to grind all the gaps that remain between the stones and the mortar. The second washing, we wash off all the stains from the pounded solution. And the third zamyvkoy bring trimming to the final neat appearance. In the deep groove, we clean the seams deeper than the surface of the stones. Triangular scraper scrape the solution between the stones to a depth of several millimeters to 2-3 cm - depending on the project. Then, in order to give smoothness, we pass through the solution with a metal brush. You can brush such stones with a brush. We clean the road with a high pressure washer. As an option: you can wash the stones and mortar with a washcloth, as in the first method, but the time is more costly and time consuming. The stripping technology is the same in all three options; The composition of the solution is the same. More information about the pavement can be found at https://stonesuccess.vip/shcool/kamennaya-doroga-vidy-zachistki/ Our services https://stonesuccess.vip/service/ What we are building now https://stonesuccess.vip/article/nashi-tekushhie-raboty/ Our news https://stonesuccess.vip/article/novosti/ The second channel STONE SUCCESS live https://www.youtube.com/channel/UCDaO8mbhbXPxRec6Fc4MIIA